Digimerge DH200 Instrucciones de operaciones descargar pdf (Pagina 41)

31

Using the Main Menu

The ALARM tab

The ALARM tab allows you to configure the

sy

stem Alarm Buzzer and Alarm Input type on

each channel (i.e. N.O and N.C (normally open

and normally closed) settings)).

1. Configure the following in the Alarm tab:

• RECORD C

AMERA: Select ALL if you want

all the cameras to record if motion is

detected. Select 1:1 if you only want the

camera that detected motion to record.

• ALARM BUZZER: Select ON or OFF to

enable or disable the system alarm buzzer.

• ALARM OUT1: Select the type of event that

will trigger an event. Select from ALL

ALARM, ALARM IN 1~8, HDD FAIL, VIDEO

LOSS, MOTION.

• ALL ALARM: Triggers an alarm output

if the hard drive fails, if there is video

loss, motion detection, or an alarm IN

trigger.

• ALARM IN1~8: Triggers an alarm

output

if a device connected to the

ALARM IN block triggers.

• HDD FAIL: Triggers an alarm if the DVR

har

d drive fails.

• VIDEO LOSS: Triggers an alarm if video

l

oss occurs.

• MOTION: Triggers an alarm if the

c

amera detects motion.

• INPUT: Select the alarm type connected to

the particular channel. Select from N.O or

N.C (Normally Open, or Normally Closed).

2. Press

ENTER to save your settings. Press

CANCEL/ESC to close remaining menu

windows.

Alarm recording will take priority over

continuous

recording, even if a camera is

disabled in standard recording parameters.

Figure 17.3 Alarm menu

TIP!

If an alarm is triggered on

the system, press the

Cancel/ESC button to

cancel the buzzer (if

enabled). Cancelling the

buzzer

will not

stop

recording.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 163 164

Comentarios a estos manuales

Sin comentarios